[Beowulf] DC Power Dist. Yields 20%

Geoff Jacobs gdjacobs at gmail.com
Tue Aug 15 17:00:59 EDT 2006

Jim Lux wrote:
> At 08:41 AM 8/11/2006, Geoff Jacobs wrote:
> Sure you would.. Actually, these days, you might use an IGBT, depending
> on the switch rate..
> Switching PSUs all rely on rectifying the AC supply to generate a DC bus
> voltage, that is then converted to the DC voltage you want.  There's a
> half dozen or so circuit topologies, but they all basically rely on
> turning the DC on and off quickly and then doing something useful with
> it.  The two basic strategies are: You turn it into high frequency AC,
> then run that through a transformer, and rectify and filter it to low
> voltage DC.  THis saves the iron and copper cost of a high power
> transfomer (since the core mass is inversely proportional to
> frequency... 20kHz or 100kHz saves a bunch over 60Hz)

Okay, just like modern inverter-based TIG supplies. :) But aren't they
already doing this at the prime rectifier to step up to 300-ish V DC?

> The other strategy is to take the HV DC, and pulsewidth modulate it,
> then filter it, to make a lower voltage (the classic "buck" converter). 
> That is, take 100VDC, turn it on and off with a 5% duty cycle, low pass
> filter, and get 5V.

I see, and switching speed is dictated by factors like desired ripple in
the output voltage for a given load while still avoiding the use of
those coke-bottle caps in the LC filter (preserving such supplies for
USAF rail-gun experiments).

Are power supplies using individual converters for each rail these days?

> Jim

Geoffrey D. Jacobs

Go to the Chinese Restaurant,
Order the Special
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf

More information about the Beowulf mailing list