[Beowulf] cisco networking
doseyg at r-networks.net
Sun Jan 10 01:29:12 EST 2010
You can have multiple ether-channel links between 2 switches. The
limitation is that if they are in the same layer 2 broadcast domain
(VLAN) only 1 will be active and STP will block the other.
If you place each switch in a separate network you could use equal cost
load balancing across multiple point to point SVI's on ether-channel
links. You'll increase bandwidth at the cost of a little additional
latency. Of course at the bandwidths you are talking about (160 Gbit/s
or more ) I have no idea how it would really work. Backplane bandwidth,
hashing algorithms and all sorts of other factor come into play and
could cause it to fail completely. I'd love to try it out but I can't
help but think there is probably a better architectural solution.
What are you trying to do ?
On Mon, 2010-01-04 at 20:54 -0500, Michael Di Domenico wrote:
> its my understanding that you can only have one lacp/etherchannel link
> between two cisco switches and that link can only comprise up to eight
> actual links
> which using 10Gbps links would yield around ~8GB/sec
> Does anyone know if it's possible to get more? Between two Cisco 6500's?
> Im pretty sure the answer is no, but i figured i'd check...
> Beowulf mailing list, Beowulf at beowulf.org sponsored by Penguin Computing
> To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
Beowulf mailing list, Beowulf at beowulf.org sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf