[Beowulf] Re: typical latencies for gigabit ethernet
patrick at myri.com
Mon Jun 29 18:22:23 EDT 2009
Dave Love wrote:
> Scott Atchley <atchley at myri.com> writes:
>> When I test Open-MX, I turn interrupt coalescing off. I run
>> omx_pingpong to determine the lowest latency (LL). If the NIC's driver
>> allows one to specify the interrupt value, I set it to LL-1.
Note that it is only meaningful wrt ping-pong latency. To optimize for
all latency cases, you just want interrupt coalescing to be off.
> results apart, probably, from the minor kernel version. If I set
> rx-frames=0, I see this:
> rx-usec latency (µs)
> 20 34.6
> 12 26.3
> 6 20.0
> 1 14.8
> whereas if I just set rx-frames=1, I get 14.7 µs, roughly independently
> of rx-usec. (Those figures are probably ±∼0.2µs.)
rx-usecs specifies the minimum time between interrupts, whereas
rx-frames specifies the number of frames (packets) between interrupts.
So, if you set rx-frames to 1, there will be an interrupt after each
packet. Not many devices implement rx-frames, since it does not
distinguish between small and large frames. Adaptive coalescing methods
do look at the size of the frames to figure out if the traffic is mostly
latency or bandwidth sensitive, but it's just a guess.
>> The downside is lower throughput for large messages on 10G Ethernet. I
>> don't think it matters on gigabit.
> It doesn't affect the ping-pong throughput significantly, but I don't
> know if it has any effect on the system overall (other cores servicing
> the interrupts) on `typical' jobs.
On GigE, each 1500 Bytes frames takes more than 10us on the wire so even
with interrupt coalescing turned off, you won't get more than 100K
interrupts per second. It used to be a problem, but it's no big deal on
recent machines. However, you can get a lot more interrupt when
receiving smaller packets, although the interrupt overhead itself would
limit the interrupt load to well below 1 Million per second. In the
worst case, you would lose a core if you don't let the OS move the
interrupt handler to do load balancing. What is one core these days ? :-)
Beowulf mailing list, Beowulf at beowulf.org sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf