[Beowulf] interconnect and compiler ?

Håkon Bugge hbugge at platform.com
Fri Jan 30 16:28:29 EST 2009


On Jan 30, 2009, at 21:24 , Vincent Diepeveen wrote:

> Now that you're busy with all this, mind quoting interconnects  
> switch latency?
>
> For example: If one of the cores c0 on our box is busy receiving a  
> long message
> from a remote node in the network, a message that will take  
> significant time,
> can it switch in between let go through a short message meant for  
> c1, and if so
> what latency time does it take to receive it for c1?
>

Vincent,

This is a good comment. Multiple DMA engines/threads in the HCA and/or  
different priority level to the DMAs are issues. I would claim, as  
usual in the HW vs. SW world, that the mechanisms are implemented in  
the hardware, but the ability of software to take advantage of this  
may not be there.

Since, small messages often are required to get trhough in order to  
start a large one, e.g. rendevouz protocols, your example is relevant.  
You might have an interest in looking at the SPEC MPI2007 results at http://www.spec.org/mpi2007/results/mpi2007.html

Here you will find different MPI implementations using equal or very  
similar hardware, and/or different interconnects.  Out of the 13  
applications constituting the SPEC MPI2007 medium suite, you will find  
the milage varies significantly.

May be related to a response (in software) to your issue?


> On Jan 30, 2009, at 6:06 PM, Greg Lindahl wrote:
>> Even logp doesn't describe an interconnect that well. It matters how
>> efficient your interconnect is at dealing with multiple cores, and  
>> the
>> number of nodes. As an example of that, MPI implementations for
>> InfiniBand generally switch over to higher latency/higher overhead
>> mechanisms as the number of nodes in a cluster rises, because the
>> lowest latency mechanism at 2 nodes doesn't scale well.
>>

[slight change of subject]

Greg, we (and your former colleagues at PathScale) have exchanged  
opinions on RDMA vs. Message Passing. Based on SPEC MPI2007, you will  
find that an RDMA based DDR interconnect using Platform MPI performs  
better than a Message Passing stack using DDR. Looking at 16 nodes,  
128 cores, Intel E5472, the Message Passing paradigm is faster on 5  
(out of 13) application, whereas Platform MPI with its RDMA paradigm  
is faster on 8 of the applications. Further, when the Message Passing  
paradigm is faster, its never faster than 7% (on pop2). On the other  
hand, when PMPI with its message passing is faster, we talk 33, 18,  
and 17%.

May be you will call it a single datapoint. But I will respond its 13  
applications. And frankly, I didn't have more gear to run on ;-)


Thanks, Håkon
_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



More information about the Beowulf mailing list