[Beowulf] What is the right lubricant for computer rack sliding rails?
Robert G. Brown
rgb at phy.duke.edu
Wed Feb 11 20:39:51 EST 2009
On Wed, 11 Feb 2009, Greg Lindahl wrote:
> On Wed, Feb 11, 2009 at 05:19:11PM +0000, John Hearns wrote:
>> Or use the little metal tool which comes in a bag of cage nuts. Which
>> themselves have nice sharp edges ready to slice your fingers of
>> course. But any big cluster demands blood sacrifice (*)
But it is SUPPOSED to be a CHICKEN.
> The guys I learned from use only screwdrivers, and I haven't been cut
> since I started doing it their way. Both kinds of little metal tool
> are worse than useless.
I just work more slowly than that, perhaps because I don't rack
all that many nodes all that often. Practice makes perfect, I'm sure.
>> I suppose Sun racks fit that bill - as they have lines of tapped holes
>> rather than square sections, but since they come with US of A size
>> holes it drives us right-pondiands frantic.
> It's easy to buy racks in the US with round holes for 12/24 screws.
> Datacenters don't seem to like them (my situation), but many HPC
> clusters have them.
> -- greg
> Beowulf mailing list, Beowulf at beowulf.org
> To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
Robert G. Brown http://www.phy.duke.edu/~rgb/
Duke University Dept. of Physics, Box 90305
Durham, N.C. 27708-0305
Phone: 1-919-660-2567 Fax: 919-660-2525 email:rgb at phy.duke.edu
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
More information about the Beowulf