[Beowulf] Re: cluster fails to boot with managed switch,but 5-port switch works OK
john.hearns at mclaren.com
Wed Dec 2 13:36:47 EST 2009
I've tried resetting the SMC switch to factory defaults (with
auto-negotiate on). I've checked the /etc/beowulf/modprobe.conf and it
doesn't seem to be demanding anything exotic. We've tried swapping out
to another SMC switch but that didn't change anything.
No idea really, as I don't use SMC switches.
First thing I would do would be to get a laptop with Linux on, and
attach it to the SMC switch.
Configure the Ethernet interface to use DHCP, then ifconfig it down then
ifcoinfig it up.
Run tcpdump eth0 as you do this, and tail -f /var/log/messages
If it gets a DHCP address (and of course on the cluster head node there
is a pool of free DHCP addresses configured)
the test tftp file transfer. Set the tftp daemon on the head node to run
in debug mode, and start it up.
Try a tftp get of a test file on the laptop.
The contents of this email are confidential and for the exclusive use of the intended recipient. If you receive this email in error you should not copy it, retransmit it, use it or disclose its contents but should return it to the sender immediately and delete your copy.
Beowulf mailing list, Beowulf at beowulf.org sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf