[Beowulf] X5500 - ECC Registered or Unbuffered?

Kilian CAVALOTTI kilian.cavalotti.work at gmail.com
Thu Apr 2 05:41:48 EDT 2009


On Thursday 02 April 2009 06:44:53 Joshua Baker-LePain wrote:
> AFAIK, the only difference is available capacity (well, and price of
> course).  You can't get unbuffered DIMMs bigger than 2GB.  Also note that
> memory speed goes down as you add more DIMMs per channel (it's also a
> function of CPU clock speed).  So if you want a fair bit of memory (read,
> more than 12GB) but also want to run it as fast as possible, you'll need
> to buy Registered DIMMs (and a fast enough CPU).

Registered DIMMs use registers (hence the name) to buffer signals, for a 
better signal integrity, which allow increased clock rates and slot capacity. 
This is done at a cost of an higher latency, though.

On the Tylersburg platform, if you only plan to use 2GB DIMMs, and no more 
than 1 DIMM per memory channel, unbuffered is probably the way to go. It will 
get you a maximum of 6GB per processor, though. If you want a higher total 
capacity and still keep the maximum frequency (1333MHz), you'll need 
registered DIMMs.


Cheers,
-- 
Kilian
_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



More information about the Beowulf mailing list