[Beowulf] Re: Yet another type of strange rack rail

matt jones jamesjamiejones at aol.com
Fri Jun 30 04:20:02 EDT 2006


the industry standard as i have been told is not the mounting system 
that includes rails. they have been an addition to the rack system and 
as such dont yet have any standards other than fitting into a 19" rack.

the standard defines that the width on the rack is 19" apx. and that a U 
is 1.75" or apx 43-45 mm (i always assume 44). it also defines the 
placement of screws and their holes on the side flanges.

unfortunately, that is about all there is the the 'industry standard', 
the rest is basically up to the manufacturer.

Leif Nixon wrote:

 > "David Mathog" <mathog at caltech.edu> writes:
 >
 > > So far I've mounted 5 different 2U cases from 4 manufacturers
 > > and no two had anything vaguely resembling the same mounting system.
 >
 > I'm always amused when I read the phrase '19" industry standard rack
 > mount'.
 >
 > --
 > Leif Nixon                       -            Systems expert
 > ------------------------------------------------------------
 > National Supercomputer Centre    -      Linkoping University
 > ------------------------------------------------------------

-- 
matt jones,

this e-mail has been virus scanned,
sent from a workstation called: matts, IP address: 10.64.63.17, Subnet
Mask: 255.255.192.1

_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list