[Beowulf] SATA II
hahn at physics.mcmaster.ca
Fri Dec 8 09:29:06 EST 2006
>> Thanks Peter,
>> But do you mean that SATA is not a suitable choice for a beowulf cluster?
> SATA is fine. You just have to be choosy about the SATA/SAS controller,
it's interesting that SAS advertising has obscured the fact that
SAS is just a further development of SCSI, and not interchangable
with SATA. for instance, no SATA controller will support any SAS disk,
and any SAS setup uses a form of encapsulation to communicate with
the foreign SATA protocol. SAS disks follow the traditional price
formula of SCSI disks (at least 4x more than non-boutique disks),
and I suspect the rest of SAS infrastructure will be in line with that.
> and be mindful of reliability issues with desktop drives.
I would claim that this is basically irrelevant for beowulf.
for small clusters (say, < 100 nodes), you'll be hitting a negligable
number of failures per year. for larger clusters, you can't afford
any non-ephemeral install on the disks anyway - reboot-with-reimage
should only take a couple minutes more than a "normal" reboot.
and if you take the no-install (NFS root) approach (which I strongly
recommend) the status of a node-local disks can be just a minor node
property to be handled by the scheduler.
by all means, buy only 5-year warranty mass-market drives, since
there's no longer any premium vs 3 or even 1-year drives.
the failure rate I've seen over the past couple years has been
quite low - probably around .1-.5% AFR (failures/disk-year).
(that's ignoring infant mortality, of course, and a reasonably
cooled operating environment; expect higher rates if your supply chain
involves piles of un-padded disks sitting on on some shop's
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf