[Beowulf] myrinet (scali) or ethernet
Hakon.Bugge at scali.com
Wed Oct 6 02:54:34 EDT 2004
At 05:51 PM 10/5/04, Patrick Geoffray wrote:
> > I am user of two clusters: One runs under myrinet and
> > the other under scali. In both cases I installed my
>Myrinet is hardware and Scali makes software. Do you run Scali's
>software on Myrinet ?
Patricia, would be nice to know if you run Scali MPI Connect (SMC) or some
older ancient versions. If you run SMC, it would be nice to know if you run:
o) Gbe through the TCP/IP stack (-net tcp)
o) Gbe through the Direct Ethernet Transport (-net det0)
o) Myrinet (-net gm0)
o) Infiniband (-net ib0)
o) 10Gbe through 3rd party DAPLs (network name will vary)
I assume you do not run combinations of the above although that is
possible. I quick sanity check of your system could be to run sample
benchmarks to assess the system(s) performance (latency and bandwidth). I
usually use bandwidth and all2all, both located in /opt/scali/examples/bin.
Another obvious check is to see if the system is idle when it is supposed
to be idle. You could use the utility scatop for that purpose.
Another way out is of course mailto:support _AT_ scali.com
>I guess there should be a way with Scali to know which device is used at
>runtime, but I really don't know how.
# SCAMPI_NETWORKS_VERBOSE=2 mpimon -net smp,gm0,tcp
/opt/scali/examples/bin/hello -- `scahosts`
Hakon.Bugge _ AT_ scali.com
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf