Channel Bonding

David McBride DMcBride at ctwenterprises.com
Sun Jan 27 14:27:32 EST 2002


Thanks for the reply.
I am trying to be able to do two different things.
1) I am trying to perform is to channel bond with a linux router that has 3
nics, 2 connected to two different cable modems and one for the lan side to
provide internet access.
2) I am trying to perform is to channel bond with a linux router that has 3
nics, 1 connected to a cable modems and one connected to a ADSL line and one
for the lan side to provide internet access, connected to a hub.

           same ISP             and         Different ISP's
 
     cable modem 1 cable modem 2         ADSL line   Cable modem
         eth0 \      / eth1                eth0 \      / eth1
               \    /                            \    /
            linux router                       linux router
                 | eth2                        eth2 |
                 |                                  |
                hub                                hub
                /|\                                /|\ 
              multiple PC's                    multiple PC's    


Thanks again for the reply and any further help,
David 


-----Original Message-----
From: abhishek Sinha [mailto:aby_sinha at yahoo.com]
Sent: Saturday, January 26, 2002 9:42 PM
To: David McBride
Subject: Re: Channel Bonding


Hi David 

Channel bonding happens with ethernet cards.
If u want to gain in more bandwidth then channel
bonding or trunking as it is known as  would be
helpful.Suppose ur box has 2 ethernet devices
configured.eth0 and eth1. if u compile the channel
bonding code and put it in the kernel they can be made
to behave as a single port.so ur beandwidth becomes
double.But some minimal time is spend in distributing
the packets at the hardware queue  level.

So it also depends upon at what rate packets are u
getting. Suppose the bandwith(Max) which ur card can
take is A and u ur getting a packet inflow rate of
about 2A then it makes sense to channel bond 2 eth
devices. Otherwise there is no point. There is more to
this. U should know how much is ur average network
traffic 

abby
--- David McBride <DMcBride at ctwenterprises.com> wrote:
> I am a total newbie to Beowulf and was wondering if
> the channel bonding
> could be used to join the bandwidth from two cable
> modems into a single
> bandwidth to get some killer speed.
> 
> Thanks,
> David
> _______________________________________________
> Beowulf mailing list, Beowulf at beowulf.org
> To change your subscription (digest mode or
> unsubscribe) visit
http://www.beowulf.org/mailman/listinfo/beowulf


=====
And I dont want the world to see me
Coz i know that they won't understand
When Everything else is meant to be broken
I just want u to know who i m ....

__________________________________________________
Do You Yahoo!?
Great stuff seeking new owners in Yahoo! Auctions! 
http://auctions.yahoo.com
_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list