How to tell when a job is swapping?

Rocky McGaugh rmcgaugh at atipa.com
Tue Feb 19 09:49:06 EST 2002


Jeff Layton wrote:

> Good morning,
> 
>    For a while now I've been checking if a job is swapping
> on our clusters using bWatch. The nodes are dual CPU
> boxes and we run two MPI processes per node. I usually
> look at the load on the nodes to see if it is above 3.0
> (sometimes our code will peak out at about 2.3) and I
> look at the free swap space number (bWatch just cats the
> /proc/meminfo file).
>    I usually assume that if the free swap space falls below
> the maximum and load starts climbing that the node is
> swapping. However, when I talk to the user, he states that
> the code is running fine and the timing numbers are where
> they should be. So, I'm obviously interpreting something
> incorrectly (unless the job is really swapping but for some
> reason performance is unaffected).
>    Does someone give me a could way to check if a job
> is swapping? Maybe a URL?
> 
> TIA,
> 
> Jeff
> 
> 


Check out the PCP stuff from SGI. 

It will pull out:

swap.in, swap.out, swap.pagesin, swap.pagesout, 
swap.free, swap.length, swap.used

It is also possible to compile the app against their tracing lib,
and get alot of info about the app itsself.

-- 
Rocky McGaugh
Atipa Technologies
rocky at atipatechnologies.com
rmcgaugh at atipa.com
1-785-841-9513 x3110
http://1087800222/
perl -e 'print unpack(u, ".=W=W+F%T:7\!A+F-O;0H`");'

_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list