Scyld with diskless
dvos12 at calvin.edu
Thu Jun 21 11:14:12 EDT 2001
On Thu, 21 Jun 2001, David Leunen wrote:
> I want to install Scyld Beowulf (2.0 Preview Release) on a cluster with
> diskless slaves. Can somebody tell me what configuration I have to do?
> My /etc/beowulf/fstab lokks like this:
> /dev/ram3 / ext2 fs_size=65536 0 0
> none /proc proc defaults 0 0
> none /dev/pts devpts gid=5,mode=620 0 0
> $MASTER:home /home nfs defaults 0 0
> Is that alright? what is the fs_size?
That looks fine. I assume fs_size is the size of the ramdisk for the /
partition. I think it is in kilobytes.
> Do I have to run beofdisk, or just to boot the slaves with boot-disks?
You only need to use beofdisk if you need to partition hard drives on the
slaves. Boot-disks should be fine.
I don't know what is wrong with your card. Are you able to configure the
card on your master? On the master you probably want to use eth0 to go to
the outside world, and have eth1 be for the beowulf slaves. You can
change that in /etc/beowulf/config
> When I boot the slave, It says:
> System boot phase 1
> eth0: 3Com 3c905c Tornado at 0x800, *** INVALID CHECKSUM 0021 ***
> sending RARP requests..
> RARP: 00:04:76:20:00:CF -> 10.0.0.10
> boot: Connecting to 10.0.0.1:1555
> Then it gets stuck. What is wrong? In beosetup, I dragged the MAC adress
> to the center panel and clicked "apply".
> (Have I misconfigured the network on the master? How can I know what
> ethernet card is the cluster one? I put eth0 for the beowulf ethernet.
> If it was the other I wouldn't see the MAC addresses in beosetup ,...
> Any help would be appreciate.
> Thank you.
> Beowulf mailing list, Beowulf at beowulf.org
> To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf