Scyld with diskless
agrajag at scyld.com
Thu Jun 21 10:59:04 EDT 2001
On Thu, 21 Jun 2001, David Leunen wrote:
> I want to install Scyld Beowulf (2.0 Preview Release) on a cluster with
> diskless slaves. Can somebody tell me what configuration I have to do?
the Preview Release is not our newest release and has known problems. I
recommend you upgrade ot 27bz-7, or wait for the new release which
should be out soon.
> My /etc/beowulf/fstab lokks like this:
> /dev/ram3 / ext2 fs_size=65536 0 0
> none /proc proc defaults 0 0
> none /dev/pts devpts gid=5,mode=620 0 0
> $MASTER:home /home nfs defaults 0 0
Nothing jumps out as wrong.
> Is that alright? what is the fs_size?
It's the size of the ramdisk
> Do I have to run beofdisk, or just to boot the slaves with boot-disks?
If you don't mind booting from floppies or cds and aren't using the
harddrive, then you don't need to run beofdisk.
> When I boot the slave, It says:
> System boot phase 1
> eth0: 3Com 3c905c Tornado at 0x800, *** INVALID CHECKSUM 0021 ***
Looks like it might be a driver issue. I had problems with that same
card with the 2.0 preview release, but it worked fine with 27bz-7.
> sending RARP requests..
> RARP: 00:04:76:20:00:CF -> 10.0.0.10
> boot: Connecting to 10.0.0.1:1555
> Then it gets stuck. What is wrong? In beosetup, I dragged the MAC adress
> to the center panel and clicked "apply".
> (Have I misconfigured the network on the master? How can I know what
> ethernet card is the cluster one? I put eth0 for the beowulf ethernet.
> If it was the other I wouldn't see the MAC addresses in beosetup ,...
From what info you've given, it looks like you did everything right.
The only problem is needing to upgrade the software.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Size: 232 bytes
Desc: not available
More information about the Beowulf