Scalapack: How to increase Grid size. !!
eswardev at yahoo.com
Tue Jul 31 21:22:11 EDT 2001
I could get rid of the TOTMEM ERROR but dont know
how to change process grid size for more than 1x1 so
that nprow*npcol can accept greater than 1 value
Right now I could only get executables run for p=1 q=1
any value more than that result in the previous
> Message: 1
> Date: Mon, 30 Jul 2001 16:44:17 -0700 (PDT)
> From: Eswar Dev <eswardev at yahoo.com>
> Subject: Scalapack Help!!
> To: beowulf at beowulf.org
> (This is my first mail to Bewoulf mailing list:)
> I need some one to help me with running
> executables on Sacalapck. Iam stuck into this
> for quite some time now.
> I was unable get good results using scalapack on
> "MPI-Linux based Bewoulf cluster with 12 nodes".
> These are error message I always get with SCALAPACK.
> 1.Bad Memory parameters: goining into the case.
> Unable to perform factorisation: need TOTMEM of at
> least 4944943 (Maximum Matrix size I can use is
> 2.ILLEGAL GRID: nprow*npcol = 8. It can atleast be
> I get rid of 2nd error only if I make Grid size 1 X
> for any other grid size results in error but that
> results in my solution time and LU time to be Zero
> which is useless. I run the executables for more
> node up to 1 nodes.
> I tried varying Parametes for M, N , NB NRHS
> but they dont seem to result in any kinda
> in SACALAPACK perfromance.
> Please help solve this Problem.
> Our website for Bewoulf is
> Thanking you,
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
More information about the Beowulf