Hostname on the slave nodes in Scyld

german kogan gkogan at students.uiuc.edu
Fri Aug 24 15:33:15 EDT 2001


When I do a bpsh 1 hostname on the front end machine I get back <none>. Is
this the way it should be?

Thanks



On Fri, 24 Aug 2001, Eric T. Miller wrote:

>
>
> The slaves will be issued names (node0, node1, etc.) during the phase three
> boot (i beleive).  Then, when you drag them to the configured nodes column,
> the MAC address will change to the node name.  There is no need to configure
> any additional naming scheme.
>
> Hope this is helpful.
>
>
>
> Hi.
>
>
> Are the slave nodes in the Scyld supposed have no hostnames? Only the
> front end machine should have the hostname?
>
> Thanks
>
>
> _______________________________________________
> Beowulf mailing list, Beowulf at beowulf.org
> To change your subscription (digest mode or unsubscribe) visit
> http://www.beowulf.org/mailman/listinfo/beowulf
>


_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list