3C905CX-TXNM - Destination Host Unreachable, but can ping card.

Chris Richard Adams chrisa at ASPATECH.COM.BR
Thu Apr 19 18:14:02 EDT 2001


I have recently installed the latest 27Bz-7 version on a new Compaq iPaq
DeskPro w/Pentium III - 750Mhz.  This installation is as master node.

Although I can ping the machine local assigned addresses, if I try to
ping any local machines on the public 10.3.1.0 side I get 'Destination
Host Unreachable' in response.  Here is my configuration:

I have new 2-3C905CX-TXNM cards installed. I set up eth0 to talk on our
local network, 10.3.1.0, with ip 10.3.1.10 & eth1 with the default
192.168.1.1.  Both load ok on boot and are shown as active- I am using
the 3c59x drivers that came with the 27Bz-7 installation.

Using Control-Panel and Linuxconf I have set up the following:

Hosts
192.168.1.1		host1		nickname1
10.3.1.10		host2		nickname2
127.0.0.1		localhost	localhost

Device	IP		Proto		Active
lo	127.0.0.1		none		active
eth0	10.3.1.10		none		active
eth1	192.168.1.1		none		active

Network Packet Forwarding IS checked
Default gateway 10.3.1.1 (this is our firewall/router)
Device eth0 ( I assumes this means- all traffic to 10.3.1.1 goes thru
eth0)

Routing
Interface	Network address	Network Mask	Gateway
eth0		10.3.1.10		255.255.255.0	10.3.1.1
eth1		192.168.1.1		255.255.255.0	


No matter what I try in altering these settings - removing the eth1 card
temporarily, and restarting the network services, etc.,., I always get
this  Destination Host Unreachable when pinging another machine.

Should I be using another driver??? Is this a driver problem to begin
with?? Please shine light my way!

Thanks!
Chris 

_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list