Installing module 3c90x.o returns: init_module:

Christian Storm christian.storm at cgr.ki.se
Mon Apr 2 07:09:22 EDT 2001


> > I had similar problem when I tried the prerelease.  However, when I
> > tried the actual release (27bz-7), this problem went away.  With the
> > 27bz-7 release it used the 3c59x driver for my 3c905C-TX ethernet card
> > and it works just fine.
> >
> >
> > Jag
> >
I have problems with the 3c90x modules, too (mainly the NIC "shutting down"
at high network load). I tried the 3c59x driver, but I only get a 10 Mbit
transfer-rate for my 3c905 cards out of it. Anything one can do to tweak it
to run at fast ethernet speed ?


Christian


_______________________________________________
Beowulf mailing list, Beowulf at beowulf.org
To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf



More information about the Beowulf mailing list