Problem Booting the Slaves
leunen.d at fsagx.ac.be
Fri Dec 15 11:44:47 EST 2000
> We recommend 128MB for the compute nodes.
> It's possible to run with only 64MB, but not less.
> This minimum memory is the same for disk-based and diskless nodes.
> The compute nodes always start as diskless nodes running from "ramdisk",
> even if they get their initial boot kernel from the hard disk.
> The nodes immediately start accepting commands from the master, before
> mounting any filesystems. Running in "diskless" mode allows the master to
> control verification of file system integrity ("fsck"), create new file
> systems, and recover checkpoint files without the risk of a node boot script
> corrupting the system.
> The bulk of the memory use is cached libraries. 'Bproc' automatically
> transports missing/uncached libraries with the application executable, thus
> not every library on the system must be cached. But the libraries used by
> the housekeeping processes ("slave daemons") on the compute node must always
> exist locally.
Alright, I try now to make a beowulf with double-PII-300Mhz 64Mb-Ram for
slaves. I think I installed everything OK with a HD, the output on the
slave is :
System boot phase 3..
Node Setup finished
I suppose that it is OK. But when I look in beostatus, I see the slave
memory is 93% full!! Why is it so big? Isn't there another solution for
that than increase memory?
My other question is How to make a Diskless??
I can't see anything in the documentation about it!
Thanks in advance.
Beowulf mailing list
Beowulf at beowulf.org
More information about the Beowulf